Internet DRAFT - draft-li-area-abstraction

draft-li-area-abstraction







Internet Engineering Task Force                                    T. Li
Internet-Draft                                           Arista Networks
Intended status: Informational                             June 28, 2018
Expires: December 30, 2018


                   Level 1 Area Abstraction for IS-IS
                      draft-li-area-abstraction-00

Abstract

   Link state routing protocols have hierarchical abstraction already
   built into them.  However, when lower levels are used for transit,
   they must expose their internal topologies, leading to scale issues.

   To avoid this, this document discusses extensions to the IS-IS
   routing protocol that would allow level 1 areas to provide transit,
   yet only inject an abstraction of the topology into level 2.

Status of This Memo

   This Internet-Draft is submitted in full conformance with the
   provisions of BCP 78 and BCP 79.

   Internet-Drafts are working documents of the Internet Engineering
   Task Force (IETF).  Note that other groups may also distribute
   working documents as Internet-Drafts.  The list of current Internet-
   Drafts is at https://datatracker.ietf.org/drafts/current/.

   Internet-Drafts are draft documents valid for a maximum of six months
   and may be updated, replaced, or obsoleted by other documents at any
   time.  It is inappropriate to use Internet-Drafts as reference
   material or to cite them other than as "work in progress."

   This Internet-Draft will expire on December 30, 2018.

Copyright Notice

   Copyright (c) 2018 IETF Trust and the persons identified as the
   document authors.  All rights reserved.

   This document is subject to BCP 78 and the IETF Trust's Legal
   Provisions Relating to IETF Documents
   (https://trustee.ietf.org/license-info) in effect on the date of
   publication of this document.  Please review these documents
   carefully, as they describe your rights and restrictions with respect
   to this document.  Code Components extracted from this document must
   include Simplified BSD License text as described in Section 4.e of



Li                      Expires December 30, 2018               [Page 1]

Internet-Draft              Area Abstraction                   June 2018


   the Trust Legal Provisions and are provided without warranty as
   described in the Simplified BSD License.

Table of Contents

   1.  Introduction  . . . . . . . . . . . . . . . . . . . . . . . .   2
     1.1.  Requirements Language . . . . . . . . . . . . . . . . . .   3
   2.  Area Abstraction  . . . . . . . . . . . . . . . . . . . . . .   3
     2.1.  Area Leader Election  . . . . . . . . . . . . . . . . . .   4
     2.2.  LSP Generation  . . . . . . . . . . . . . . . . . . . . .   4
     2.3.  Redundancy  . . . . . . . . . . . . . . . . . . . . . . .   5
   3.  Area Pseudonode TLV . . . . . . . . . . . . . . . . . . . . .   5
   4.  Acknowledgements  . . . . . . . . . . . . . . . . . . . . . .   5
   5.  IANA Considerations . . . . . . . . . . . . . . . . . . . . .   5
   6.  Security Considerations . . . . . . . . . . . . . . . . . . .   5
   7.  References  . . . . . . . . . . . . . . . . . . . . . . . . .   6
     7.1.  Normative References  . . . . . . . . . . . . . . . . . .   6
     7.2.  Informative References  . . . . . . . . . . . . . . . . .   6
   Author's Address  . . . . . . . . . . . . . . . . . . . . . . . .   6

1.  Introduction

   The IS-IS routing protocol IS-IS [ISO10589] currently supports a two
   level hierarchy of abstraction.  The fundamental unit of abstraction
   is the 'area', which is a (hopefully) connected set of systems
   running IS-IS at the same level.  Level 1, the lowest level, is
   abstracted by routers that participate in both Level 1 and Level 2,
   and they inject area information into Level 2.  Level 2 systems
   seeking to access Level 1, use this abstraction to compute the
   shortest path to the Level 1 area.  The full topology database of
   Level 1 is not injected into Level 2, only a summary of the address
   space contained within the area, so the scalability of the Level 2
   link state database is protected.

   This works well if the Level 1 area is tangential to the Level 2
   area.  This also works well if there are a number of routers in both
   Level 1 and Level 2 and they are adjacent, so Level 2 traffic will
   never need to transit Level 1 only routers.  Level 1 will not contain
   any Level 2 topology, and Level 2 will only contain area abstractions
   for Level 1.

   Unfortunately, this scheme does not work so well if the Level 1 area
   needs to provide transit for Level 2 traffic.  For Level 2 shortest
   path first (SPF) computations to work correctly, the transit topology
   must also appear in the Level 2 link state database.  This implies
   that all routers that could possibly provide transit, plus any links
   that might also provide Level 2 transit must also become part of the




Li                      Expires December 30, 2018               [Page 2]

Internet-Draft              Area Abstraction                   June 2018


   Level 2 topology.  If this is a relatively tiny portion of the Level
   1 area, this is not onerous.

   However, with today's data center topologies, this is problematic.  A
   common application is to use a Layer 3 Leaf-Spine (L3LS) topology,
   which is a folded 3-stage Clos [Clos] fabric.  It can also be thought
   of as a complete bipartite graph.  In such a topology, the desire is
   to use Level 1 to contain the routing of the entire L3LS topology and
   then to use Level 2 for the remainder of the network.  Leaves in the
   L3LS topology are appropriate for connection outside of the data
   center itself, so they would provide connectivity for Level 2.  If
   there are multiple connections to Level 2 for redundancy, or to other
   areas, these too would also be made to the leaves in the topology.
   This creates a difficulty because there are now multiple Level 2
   leaves in the topology, with connectivity between the leaves provide
   by the spines.

   Following the rules of IS-IS, all spine routers would necessarily be
   part of the Level 2 topology, plus all links between a Level 2 leaf
   and the spines.  In the limit, where all leaves need to support Level
   2, it implies that the entire L3LS topology becomes part of Level 2.
   This is seriously problematic as it more than doubles the link state
   database held in the L3LS topology and eliminates any benefits of the
   hierarchy.

1.1.  Requirements Language

   The key words "MUST", "MUST NOT", "REQUIRED", "SHALL", "SHALL NOT",
   "SHOULD", "SHOULD NOT", "RECOMMENDED", "MAY", and "OPTIONAL" in this
   document are to be interpreted as described in RFC 2119 [RFC2119].

2.  Area Abstraction

   We propose to completely abstract away the Level 2 topology of the
   Level 1 area, making the entire area look like a single system
   directly connected to all of the area's Level 2 neighbors.  By only
   providing an abstraction of the topology, Level 2's requirement for
   connectivity can be satisfied without the full overhead of the area's
   internal topology.  It then becomes the responsibility of the Level 1
   area to ensure the forwarding connectivity that's advertised.

   We propose to implement Area Abstraction by having a Level 2
   pseudonode that represents the entire Level 1 area.  This is the only
   LSP from the area that will be injected into the overall Level 2 link
   state database.

   There are three classes of routers that we need to be concerned with
   in this discussion:



Li                      Expires December 30, 2018               [Page 3]

Internet-Draft              Area Abstraction                   June 2018


   Area Leader  The Area Leader is a router in the Level 1 area that is
      elected to represent the Level 1 area by injecting an LSP into the
      Level 2 link state database.

   Area Edge Router  An Area Edge Router is a router that is part of the
      Level 1 area and has at least one Level 2 interface outside of the
      Area.

   Area Neighbor  An Area Neighbor is a Level 2 router that is outside
      of the Level 1 Area.

   The Area Leader has several responsibilities.  First, it must inject
   a pseudonode identifier into the Level 1 link state database.  This
   is the Area Pseudonode Identifier.  Second, the Area Leader must
   generate the pseudonode LSP for the Area.

   All Area Edge Routers learn the Area Pseudonode Identifier from the
   Level 1 link state database and use that as the identifier in their
   Level 2 IS-IS Hello PDUs on interfaces outside the Level 1 area.  The
   Area Edge Routers MUST also maintain an Level 2 adjacency with the
   Area Leader, either via a direct link or via a tunnel.

   Area Edge Routers MUST be able to provide transit to Level 2 traffic.
   We propose that the Area Edge Routers use Segment Routing (SR)
   [I-D.ietf-spring-segment-routing] and, during Level 2 SPF
   computation, use the SR forwarding path to reach the exit Area Edge
   Routers.

2.1.  Area Leader Election

   The Area Leader is selected using the election mechanisms described
   in Dynamic Flooding for IS-IS [I-D.li-dynamic-flooding].

2.2.  LSP Generation

   Area Edge Routers generate a Level 2 LSP that includes adjacencies to
   any Area Neighbors and the Area Leader.  This LSP is not advertised
   outside of the area.

   The Area Leader uses the Level 2 LSPs generated by the Area Edge
   Routers to generate the Area Pseudonode LSP.  This LSP is originated
   using the Area Pseudonode Identifier and includes adjacencies for all
   of the Area Neighbors that have been advertised by the Area Edge
   Routers.  The Area Pseudonode LSP is the only LSP that is injected
   into the overall Level 2 link state database, with all other Level 2
   LSPs from the area being filtered out at the area boundary.





Li                      Expires December 30, 2018               [Page 4]

Internet-Draft              Area Abstraction                   June 2018


2.3.  Redundancy

   If the Area Leader fails, another candidate may become Area Leader
   and MUST regenerate the Area Pseudonode LSP.  The failure of the Area
   Leader is not visible outside of the area and appears to simply be an
   update of the Area Pseudonode LSP.

3.  Area Pseudonode TLV

   The Area Pseudonode TLV allows the Area Leader to advertise the
   existence of an Area Pseudonode Identifier.  This TLV is injected
   into one of the Area Leader's Level 1 LSPs.

   The format of the Area Pseudonode TLV is:

       0                   1                   2
       0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 2 3
      +-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
      | TLV Type      | TLV Length    | Pseudonode ID |
      +-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
      | Pseudonode ID continued ...
      +-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+

      TLV Type: XXX

      TLV Length: 2 + (length of a system ID + 1)

      Pseudonode ID: A pseudonode ID, which is the length of a system ID
      plus one octet.  field.

4.  Acknowledgements

   To be written.

5.  IANA Considerations

   This memo requests that IANA allocate and assign one code point from
   the IS-IS TLV Codepoints registry for the Area Pseudonode TLV.

6.  Security Considerations

   This document introduces no new security issues.  Security of routing
   within a domain is already addressed as part of the routing protocols
   themselves.  This document proposes no changes to those security
   architectures.






Li                      Expires December 30, 2018               [Page 5]

Internet-Draft              Area Abstraction                   June 2018


7.  References

7.1.  Normative References

   [I-D.ietf-spring-segment-routing]
              Filsfils, C., Previdi, S., Ginsberg, L., Decraene, B.,
              Litkowski, S., and R. Shakir, "Segment Routing
              Architecture", draft-ietf-spring-segment-routing-15 (work
              in progress), January 2018.

   [I-D.li-dynamic-flooding]
              Li, T. and P. Psenak, "Dynamic Flooding on Dense Graphs",
              draft-li-dynamic-flooding-05 (work in progress), June
              2018.

   [ISO10589]
              International Organization for Standardization,
              "Intermediate System to Intermediate System Intra-Domain
              Routing Exchange Protocol for use in Conjunction with the
              Protocol for Providing the Connectionless-mode Network
              Service (ISO 8473)", ISO/IEC 10589:2002, Nov. 2002.

   [RFC2119]  Bradner, S., "Key words for use in RFCs to Indicate
              Requirement Levels", BCP 14, RFC 2119,
              DOI 10.17487/RFC2119, March 1997,
              <https://www.rfc-editor.org/info/rfc2119>.

7.2.  Informative References

   [Clos]     Clos, C., "A Study of Non-Blocking Switching Networks",
              The Bell System Technical Journal Vol. 32(2), DOI
              10.1002/j.1538-7305.1953.tb01433.x, March 1953,
              <http://dx.doi.org/10.1002/j.1538-7305.1953.tb01433.x>.

Author's Address

   Tony Li
   Arista Networks
   5453 Great America Parkway
   Santa Clara, California  95054
   USA

   Email: tony.li@tony.li








Li                      Expires December 30, 2018               [Page 6]