Network Working Group F. Martin, Ed. Internet-Draft LinkedIn Updates: 5321 (if approved) A. Peterson, Ed. Intended status: Standards Track Message Systems Expires: May 18, 2014 November 14, 2013 SMTP target host selection in Mixed IPv4/IPv6 environments draft-martin-smtp-target-host-selection-ipv4-ipv6-00 Abstract The Simple Mail Transfer Protocol (SMTP) is defined in [RFC5321]. Section 5 of that document describes the process of host selection. While locating the target host in IPv4 is well defined, this process is unclear for sytems in IPv4 and IPv6 environemts. This specification extends [RFC5321] to provide a standard way of selecting the target host in mixed environements. Status of This Memo This Internet-Draft is submitted in full conformance with the provisions of BCP 78 and BCP 79. Internet-Drafts are working documents of the Internet Engineering Task Force (IETF). Note that other groups may also distribute working documents as Internet-Drafts. The list of current Internet- Drafts is at http://datatracker.ietf.org/drafts/current/. Internet-Drafts are draft documents valid for a maximum of six months and may be updated, replaced, or obsoleted by other documents at any time. It is inappropriate to use Internet-Drafts as reference material or to cite them other than as "work in progress." This Internet-Draft will expire on May 18, 2014. Copyright Notice Copyright (c) 2013 IETF Trust and the persons identified as the document authors. All rights reserved. This document is subject to BCP 78 and the IETF Trust's Legal Provisions Relating to IETF Documents (http://trustee.ietf.org/license-info) in effect on the date of publication of this document. Please review these documents carefully, as they describe your rights and restrictions with respect to this document. Code Components extracted from this document must include Simplified BSD License text as described in Section 4.e of Martin & Peterson Expires May 18, 2014 [Page 1] Internet-Draft SMTP host selection with IPv4/v6 November 2013 the Trust Legal Provisions and are provided without warranty as described in the Simplified BSD License. Table of Contents 1. Introduction . . . . . . . . . . . . . . . . . . . . . . . . 2 1.1. Requirements Language . . . . . . . . . . . . . . . . . . 2 1.2. Rationale . . . . . . . . . . . . . . . . . . . . . . . . 2 2. Locating the target host . . . . . . . . . . . . . . . . . . 3 3. Acknowledgements . . . . . . . . . . . . . . . . . . . . . . 4 4. IANA Considerations . . . . . . . . . . . . . . . . . . . . . 4 5. Security Considerations . . . . . . . . . . . . . . . . . . . 4 6. References . . . . . . . . . . . . . . . . . . . . . . . . . 4 6.1. Normative References . . . . . . . . . . . . . . . . . . 4 6.2. Informative References . . . . . . . . . . . . . . . . . 4 Appendix A. Examples . . . . . . . . . . . . . . . . . . . . . . 4 A.1. Target list . . . . . . . . . . . . . . . . . . . . . . . 4 A.1.1. Example 1: dual stacked servers . . . . . . . . . . . 5 A.1.2. Example 2: single stacked servers . . . . . . . . . . 5 A.1.3. Example 3: single and dual stacked servers . . . . . 5 Authors' Addresses . . . . . . . . . . . . . . . . . . . . . . . 6 1. Introduction Target host selection is discussed in [RFC5321] section 5 and some operational experience is described in [RFC3974]. However the process is unclear when selecting the target host in a mixed environment. Several widely deployed open source MTA do not make this selection the same and sometimes do not find all the hosts. This specification addresses the issue of host selection in mixed environments. 1.1. Requirements Language The key words "MUST", "MUST NOT", "REQUIRED", "SHALL", "SHALL NOT", "SHOULD", "SHOULD NOT", "RECOMMENDED", "MAY", and "OPTIONAL" in this document are to be interpreted as described in RFC 2119 [RFC2119]. 1.2. Rationale Martin & Peterson Expires May 18, 2014 [Page 2] Internet-Draft SMTP host selection with IPv4/v6 November 2013 [RFC5321] section 5.2 specifically discusses SMTP implementations taking into account 'local circumstances' when deciding which network addresses to use. However, neither it nor [RFC3974] explore what 'local circumstances' should be evaluated or how they should be evaluated. The result has thus far been an inconsistent set of SMTP client implementations. Providing a guideline for how SMTP client implementations should handle various dual-stack situations will improve the stability of the network while we operate in a dual- stack mode (which will likely be for an extended period of time). 2. Locating the target host This part applies if one or more MX Resource Records (RR) [RFC1035] are found for a given name and if the sender-SMTP server is IPV4 and/ or IPv6 capable. When a domain name associated with an MX RR is looked up and the associated data field obtained, the data field of that response MUST contain a domain name. That domain name is queried for A RR if the sender-SMTP is IPv4 capable and is queried for AAAA RR if the sender- SMTP is IPv6 capable. A list of IPv4 and IPv6 addresses of the SMTP servers to which the message should be directed is therefore built. When there are more than one MX RR associated to the given domain, the above process is done for each MX RR. An ordered list of IPv4 and IPv6 addresses is then established using the MX RR preference. Lower numbers are more preferred than higher ones. The sender-SMTP server first tries all the IP addresses (IPv4 and IPv6) with higher preference (lower number) before the IP addresses with lower preference (higher number). The sender-SMTP server tries all the addresses up to a limit before deciding if the message is deliverable or not. The sender-SMTP server tries at least two addresses in each IP familly it is enabled (2 IPv4 addresses if IPv4 capable and 2 IPv6 addresses if IPv6 capable). For the same MX RR preference, when there is more than one IP address (IPv4/IPv6) to be tried, the sender-SMTP SHOULD maintain an internal sub preference list based on the rate of successful delivery of messages and based on the speed of such delivery. If such internal sub preference list is not established or cannot be established then the sender-SMTP tries randomly any address within the same preference. Using this method the sender-SMTP will not prefer IP addresses it cannot connect to, or IP addresses with more rejection or latency. In some ways, this strategy is similar to the Happy Eveballs [RFC6555] strategy where web browsers initiate parralel connections to web servers using IPv4 and IPv6 and select the connection with better response. It is however not similar, because Martin & Peterson Expires May 18, 2014 [Page 3] Internet-Draft SMTP host selection with IPv4/v6 November 2013 the sender-SMTP does not try to establish a connection to all the MX RR in parralel but remembers for a period of time which connection, for IP addresses with same MX RR preference, had better response. 3. Acknowledgements Thanks to Murray Kucheraway for guidance in getting this draft out. 4. IANA Considerations This section has no action requested of IANA. [RFC Editor: Please remove this section before publication.] 5. Security Considerations Rogue sender-SMTP do not follow MX RR preferences, this existed over IPv4 and common defense can be used over IPv6 6. References 6.1. Normative References [RFC1035] Mockapetris, P., "Domain names - implementation and specification", STD 13, RFC 1035, November 1987. [RFC2119] Bradner, S., "Key words for use in RFCs to Indicate Requirement Levels", BCP 14, RFC 2119, March 1997. [RFC3552] Rescorla, E. and B. Korver, "Guidelines for Writing RFC Text on Security Considerations", BCP 72, RFC 3552, July 2003. [RFC5321] Klensin, J., "Simple Mail Transfer Protocol", RFC 5321, October 2008. [RFC6555] Wing, D. and A. Yourtchenko, "Happy Eyeballs: Success with Dual-Stack Hosts", RFC 6555, April 2012. 6.2. Informative References [RFC3974] Nakamura, M. and J. Hagino, "SMTP Operational Experience in Mixed IPv4/v6 Environments", RFC 3974, January 2005. Appendix A. Examples A.1. Target list Martin & Peterson Expires May 18, 2014 [Page 4] Internet-Draft SMTP host selection with IPv4/v6 November 2013 A.1.1. Example 1: dual stacked servers For example, a site with dual stacked servers may have the following DNS definitions: example.org. IN MX 1 mx1.example.org. IN MX 10 mx10.example.org. mx1.example.org. IN AAAA 2001:db8:ffff::1 IN A 192.0.2.1 mx10.example.org. IN AAAA 2001:db8:ffff::2 IN A 192.0.2.2 The ordered preference list will look initially: 1 2001:db8:ffff::1 1 192.0.2.1 10 2001:db8:ffff::2 10 192.0.2.2 A.1.2. Example 2: single stacked servers For example, a site with single stacked servers may have the following DNS definitions: example.org. IN MX 1 mx1-6.example.org. IN MX 1 mx1.example.org IN MX 10 mx10-6.example.org. IN MX 10 mx10.example.org mx1-6.example.org. IN AAAA 2001:db8:ffff::1 mx1.example.org. IN A 192.0.2.1 mx10-6.example.org. IN AAAA 2001:db8:ffff::2 mx10.example.org IN A 192.0.2.2 The ordered preference list will look initially: 1 2001:db8:ffff::1 1 192.0.2.1 10 2001:db8:ffff::2 10 192.0.2.2 A.1.3. Example 3: single and dual stacked servers For example, a site with a mix of single and dual stacked servers may have the following DNS definitions: Martin & Peterson Expires May 18, 2014 [Page 5] Internet-Draft SMTP host selection with IPv4/v6 November 2013 example.org. IN MX 1 mx1.example.org. IN MX 1 mx1-6.example.org IN MX 1 mx2.example.org IN MX 10 mx10.example.org. mx1.example.org. IN A 192.0.2.1 mx1-6.example.org. IN AAAA 2001:db8:ffff::1 mx2.example.org. IN A 192.0.2.2 mx10.example.org. IN AAAA 2001:db8:ffff::2 mx10.example.org IN A 192.0.2.3 The ordered preference list will look initially: 1 192.0.2.1 1 2001:db8:ffff::1 1 192.0.2.2 10 2001:db8:ffff::2 10 192.0.2.3 Authors' Addresses Franck Martin (editor) LinkedIn Mountain View, CA US Email: fmartin@linkedin.com Alec Peterson (editor) Message Systems Columbia, MD US Email: alec@messagesystems.com Martin & Peterson Expires May 18, 2014 [Page 6]