Internet Draft Lou Berger (LabN) Updates: 2205, 3209, 3473 Francois Le Faucheur (Cisco) Category: Standards Track Ashok Narayanan (Cisco) Expiration Date: August 16, 2012 February 16, 2012 RSVP Association Object Extensions draft-ietf-ccamp-assoc-ext-02.txt Abstract The RSVP ASSOCIATION object was defined in the context of GMPLS (Generalized Multi-Protocol Label Switching) controlled label switched paths (LSPs). In this context, the object is used to associate recovery LSPs with the LSP they are protecting. This object also has broader applicability as a mechanism to associate RSVP state, and this document defines how the ASSOCIATION object can be more generally applied. This document also defines extended ASSOCIATION objects which, in particular, can be used in the context of Transport Profile of Multiprotocol Label Switching (MPLS-TP). This document updates RFC 2205, RFC 3209, and RFC 3473. Status of this Memo This Internet-Draft is submitted in full conformance with the provisions of BCP 78 and BCP 79. Internet-Drafts are working documents of the Internet Engineering Task Force (IETF), its areas, and its working groups. Note that other groups may also distribute working documents as Internet- Drafts. Internet-Drafts are draft documents valid for a maximum of six months and may be updated, replaced, or obsoleted by other documents at any time. It is inappropriate to use Internet-Drafts as reference material or to cite them other than as "work in progress." The list of current Internet-Drafts can be accessed at http://www.ietf.org/1id-abstracts.html The list of Internet-Draft Shadow Directories can be accessed at http://www.ietf.org/shadow.html This Internet-Draft will expire on August 16, 2012 Berger, et al Standards Track [Page 1] Internet-Draft draft-ietf-ccamp-assoc-ext-02.txt February 16, 2012 Copyright and License Notice Copyright (c) 2012 IETF Trust and the persons identified as the document authors. All rights reserved. This document is subject to BCP 78 and the IETF Trust's Legal Provisions Relating to IETF Documents (http://trustee.ietf.org/license-info) in effect on the date of publication of this document. Please review these documents carefully, as they describe your rights and restrictions with respect to this document. Code Components extracted from this document must include Simplified BSD License text as described in Section 4.e of the Trust Legal Provisions and are provided without warranty as described in the Simplified BSD License. Table of Contents 1 Introduction ........................................... 3 1.1 Conventions Used In This Document ...................... 4 2 Non-GMPLS Recovery Usage ............................... 4 2.1 Upstream Initiated Association ......................... 4 2.1.1 Path Message Format .................................... 5 2.1.2 Path Message Processing ................................ 5 2.2 Downstream Initiated Association ....................... 7 2.2.1 Resv Message Format .................................... 7 2.2.2 Resv Message Processing ................................ 7 2.3 Association Types ...................................... 8 2.3.1 Resource Sharing Association Type ...................... 8 3 IPv4 and IPv6 Extended ASSOCIATION Objects ............. 9 3.1 IPv4 and IPv6 Extended ASSOCIATION Object Format ....... 10 3.2 Processing ............................................. 11 4 Security Considerations ................................ 13 5 IANA Considerations .................................... 13 5.1 IPv4 and IPv6 Extended ASSOCIATION Objects ............. 13 5.2 Resource Sharing Association Type ...................... 14 6 Acknowledgments ........................................ 14 7 References ............................................. 14 7.1 Normative References ................................... 14 7.2 Informative References ................................. 15 8 Authors' Addresses ..................................... 15 Berger, et al Standards Track [Page 2] Internet-Draft draft-ietf-ccamp-assoc-ext-02.txt February 16, 2012 1. Introduction End-to-end and segment recovery are defined for GMPLS (Generalized Multi-Protocol Label Switching) controlled label switched paths (LSPs) in [RFC4872] and [RFC4873] respectively. Both definitions use the ASSOCIATION object to associate recovery LSPs with the LSP they are protecting. Additional narrative on how such associations are to be identified is also provided in [ASSOC-INFO]. This document expands the possible usage of the ASSOCIATION object to non-GMPLS recovery contexts. This document reviews how association should be made in the case where the object is carried in a Path message and defines usage with Resv messages. This section also discusses usage of the ASSOCIATION object outside the context of GMPLS LSPs. Some examples of non-LSP association in order to enable resource sharing are: o Voice Call-Waiting: A bidirectional voice call between two endpoints A and B is signaled using two separate unidirectional RSVP reservations for the flows A->B and B->A. If endpoint A wishes to put the A-B call on hold and join a separate A-C call, it is desirable that network resources on common links be shared between the A-B and A-C calls. The B->A and C->A subflows of the call can share resources using existing RSVP sharing mechanisms, but only if they use the same destination IP addresses and ports. However, there is no way in RSVP today to share the resources between the A->B and A->C subflows of the call since by definition the RSVP reservations for these subflows must have different IP addresses in the SESSION objects. o Voice Shared Line: A single number that rings multiple endpoints (which may be geographically diverse), such as phone lines on a manager's desk and their assistant. A VoIP system that models these calls as multiple P2P unicast pre-ring reservations would result in significantly over-counting bandwidth on shared links, since today unicast reservations to different endpoints cannot share bandwidth. o Symmetric NAT: RSVP permits sharing of resources between multiple flows addressed to the same destination D, even from different senders S1 and S2. However, if D is behind a NAT operating in symmetric mode [RFC5389], it is possible that the destination port of the flows S1->D and S2->D may be different outside the NAT. In this case, these flows cannot share resources using RSVP today, since the SESSION objects for these two flows outside the NAT would have different ports. Berger, et al Standards Track [Page 3] Internet-Draft draft-ietf-ccamp-assoc-ext-02.txt February 16, 2012 This document also defines the extended ASSOCIATION objects which can be used in the context of Transport Profile of Multiprotocol Label Switching (MPLS-TP). Although, the scope of the extended ASSOCIATION objects is not limited to MPLS-TP. 1.1. Conventions Used In This Document The key words "MUST", "MUST NOT", "REQUIRED", "SHALL", "SHALL NOT", "SHOULD", "SHOULD NOT", "RECOMMENDED", "MAY", and "OPTIONAL" in this document are to be interpreted as described in [RFC2119]. 2. Non-GMPLS Recovery Usage While the ASSOCIATION object, [RFC4872], is defined in the context of GMPLS Recovery, the object can have wider application. [RFC4872] defines the object to be used to "associate LSPs with each other", and then defines an Association Type field to identify the type of association being identified. It also defines that the Association Type field is to be considered when determining association, i.e., there may be type-specific association rules. As defined by [RFC4872] and reviewed in [ASSOC-INFO], this is the case for Recovery type association objects. [ASSOC-INFO], notably the text related to resource sharing types, can also be used as the foundation for a generic method for associating LSPs when there is no type-specific association defined. The remainder of this section defines the general rules to be followed when processing ASSOCIATION objects. Object usage in both Path and Resv messages is discussed. The usage applies equally to GMPLS LSPs [RFC3473], MPLS LSPs [RFC3209] and non-LSP RSVP sessions [RFC2205], [RFC2207], [RFC3175] and [RFC4860]. As described below, association is always done based on matching either Path state to Path state, or Resv state to Resv state, but not Path state to Resv State. Note that there are times when no matching state is found, e.g., when processing an initial LSP or when the ASSOCIATION object contains otherwise useful information, and such cases do not alter the processing defined below. This section applies to the ASSOCIATION objects defined in [RFC4872]. 2.1. Upstream Initiated Association Upstream initiated association is represented in ASSOCIATION objects carried in Path messages and can be used to associate RSVP Path state across MPLS Tunnels / RSVP sessions. (Note, per [RFC3209], an MPLS tunnel is represented by a RSVP SESSION object, and multiple LSPs may be represented within a single tunnel.) Cross-session association based on Path state is defined in [RFC4872]. This definition is extended by this section, which defined generic association rules and Berger, et al Standards Track [Page 4] Internet-Draft draft-ietf-ccamp-assoc-ext-02.txt February 16, 2012 usage for non-LSP uses. This section does not modify processing required to support [RFC4872] and [RFC4873], and which is reviewed in Section 3 of [ASSOC-INFO]. The use of an ASSOCIATION object in a single session is not precluded. 2.1.1. Path Message Format This section provides the Backus-Naur Form (BNF), see [RFC5511], for Path messages containing ASSOCIATION objects. BNF is provided for both MPLS and for non-LSP session usage. Unmodified RSVP message formats and some optional objects are not listed. The format for MPLS and GMPLS sessions is unmodified from [RFC4872], and can be represented based on the BNF in [RFC3209] as: ::= [ ] [ ] [ ] [ ... ] [ ... ] The format for non-LSP sessions as based on the BNF in [RFC2205] is: ::= [ ] [ ... ] [ ... ] [ ] In general, relative ordering of ASSOCIATION objects with respect to each other as well as with respect to other objects is not significant. Relative ordering of ASSOCIATION objects of the same type SHOULD be preserved by transit nodes. 2.1.2. Path Message Processing This section is based on the processing rules described in [RFC4872] and [RFC4873], and which is reviewed in [ASSOC-INFO]. These procedures apply equally to GMPLS LSPs, MPLS LSPs and non-LSP session state. A node initiating a Path message chooses when an ASSOCIATION object is to be included in the outgoing Path message. A node that wishes to allow downstream nodes to associate Path state across RSVP Berger, et al Standards Track [Page 5] Internet-Draft draft-ietf-ccamp-assoc-ext-02.txt February 16, 2012 sessions MUST include an ASSOCIATION object in the outgoing Path messages corresponding to the RSVP sessions to be associated. In the absence of Association Type-specific rules for identifying association, the included ASSOCIATION objects MUST be identical across all associated sessions. When there is an Association Type- specific definition of association rules, the definition SHOULD allow for association based on identical ASSOCIATION objects. This document does not define any Association Type-specific rules. (See Section 3 of [ASSOC-INFO] for a review of Association Type-specific rules derived from [RFC4872].) When creating an ASSOCIATION object, the originator MUST format the object as defined in Section 16.1 of [RFC4872]. The originator MUST set the Association Type field based on the type of association being identified. The Association ID field MUST be set to a value that uniquely identifies the sessions to be associated within the context of the Association Source field. The Association Source field MUST be set to a unique address assigned to the node originating the association. A downstream node can identify an upstream initiated association by performing the following checks. When a node receives a Path message it MUST check each ASSOCIATION object received in the Path message to see if it contains an Association Type field value supported by the node. For each ASSOCIATION object containing a supported association type, the node MUST then check to see if the object matches an ASSOCIATION object received in any other Path message. To perform this matching, a node MUST examine the Path state of all other sessions and compare the fields contained in the newly received ASSOCIATION object with the fields contained in the Path state's ASSOCIATION objects. An association is deemed to exist when the same values are carried in all fields of the ASSOCIATION objects being compared. Type-specific processing of ASSOCIATION objects is outside the scope of this document. Note that as more than one association may exist, the described matching MUST continue after a match is identified, and MUST be performed against all local Path state. It is also possible for there to be no match identified. Unless there are type-specific processing rules, downstream nodes MUST forward all ASSOCIATION objects received in a Path message in any corresponding outgoing Path messages. Berger, et al Standards Track [Page 6] Internet-Draft draft-ietf-ccamp-assoc-ext-02.txt February 16, 2012 2.2. Downstream Initiated Association Downstream initiated association is represented in ASSOCIATION objects carried in Resv messages and can be used to associate RSVP Resv state across MPLS Tunnels / RSVP sessions. Cross-session association based on Path state is defined in [RFC4872]. This section defines cross-session association based on Resv state. This section places no additional requirements on implementations supporting [RFC4872] and [RFC4873]. Note, the use of an ASSOCIATION object in a single session is not precluded. 2.2.1. Resv Message Format This section provides the Backus-Naur Form (BNF), see [RFC5511], for Resv messages containing ASSOCIATION objects. BNF is provided for both MPLS and for non-LSP session usage. Unmodified RSVP message formats and some optional objects are not listed. The format for MPLS, GMPLS and non-LSP sessions are identical, and is represented based on the BNF in [RFC2205] and [RFC3209]: ::= [ ] [ ] [ ] [ ... ] [ ... ]