Network Working Group C. Cardona Internet-Draft P. Lucente Intended status: Standards Track NTT Expires: May 3, 2020 P. Francois INSA Y. Gu Huawei T. Graf Swisscom October 31, 2019 BMP Extension for Path Marking TLV draft-cppy-grow-bmp-path-marking-tlv-01 Abstract The BGP Monitoring Protocol (BMP) provides an interface for obtaining BGP Path information. BGP Path Information is conveyed within BMP Route Monitoring (RM) messages. This document proposes an extension to BMP to convey the status of a BGP path after being processed by the BGP best-path selection algorithm. This extension makes use of the TLV mechanims described in draft-lucente-bmp-tlv [I-D.lucente-bmp-tlv]. Requirements Language The key words "MUST", "MUST NOT", "REQUIRED", "SHALL", "SHALL NOT", "SHOULD", "SHOULD NOT", "RECOMMENDED", "NOT RECOMMENDED", "MAY", and "OPTIONAL" in this document are to be interpreted as described in BCP 14 RFC 2119 [RFC2119] RFC 8174 [RFC8174] when, and only when, they appear in all capitals, as shown here. Status of This Memo This Internet-Draft is submitted in full conformance with the provisions of BCP 78 and BCP 79. Internet-Drafts are working documents of the Internet Engineering Task Force (IETF). Note that other groups may also distribute working documents as Internet-Drafts. The list of current Internet- Drafts is at https://datatracker.ietf.org/drafts/current/. Internet-Drafts are draft documents valid for a maximum of six months and may be updated, replaced, or obsoleted by other documents at any time. It is inappropriate to use Internet-Drafts as reference material or to cite them other than as "work in progress." Cardona, et al. Expires May 3, 2020 [Page 1] Internet-Draft BMP path marking tlv October 2019 This Internet-Draft will expire on May 3, 2020. Copyright Notice Copyright (c) 2019 IETF Trust and the persons identified as the document authors. All rights reserved. This document is subject to BCP 78 and the IETF Trust's Legal Provisions Relating to IETF Documents (https://trustee.ietf.org/license-info) in effect on the date of publication of this document. Please review these documents carefully, as they describe your rights and restrictions with respect to this document. Code Components extracted from this document must include Simplified BSD License text as described in Section 4.e of the Trust Legal Provisions and are provided without warranty as described in the Simplified BSD License. Table of Contents 1. Introduction . . . . . . . . . . . . . . . . . . . . . . . . 2 2. Path Marking TLV for the RM Message . . . . . . . . . . . . . 3 2.1. Path Type . . . . . . . . . . . . . . . . . . . . . . . . 4 2.2. Reason String . . . . . . . . . . . . . . . . . . . . . . 4 3. Acknowledgements . . . . . . . . . . . . . . . . . . . . . . 6 4. IANA Considerations . . . . . . . . . . . . . . . . . . . . . 6 4.1. Path Marking TLV . . . . . . . . . . . . . . . . . . . . 6 4.2. Path Marking TLV Reason String . . . . . . . . . . . . . 6 5. Security Considerations . . . . . . . . . . . . . . . . . . . 6 6. Normative References . . . . . . . . . . . . . . . . . . . . 6 Authors' Addresses . . . . . . . . . . . . . . . . . . . . . . . 7 1. Introduction For a given prefix, multiple paths with different path status, e.g., the "best-path", "back-up path" and so on, may co-exist in the BGP RIB after being processed by the local policy and the BGP decision process. The path status information is currently not carried in the BGP Update Message RFC4271 [RFC4271] or in the BMP Update Message RFC7854 [RFC7854]. External systems can use the path status for various applications. The path status is commonly checked by operators when performing troubleshooting. Having such status stored in a centralized system can enable the development of tools facilitating this process. Optimisation systems can include the path status in their process, and also use the status as a validation source (since it can compare the calculated state to the actual outcome of the network, such as primary and backup path). As a final example, path status Cardona, et al. Expires May 3, 2020 [Page 2] Internet-Draft BMP path marking tlv October 2019 information can complement other centralized sources of data, for example, flow collectors. This document defines a so-called Path Marking TLV to convey the BGP path status information to the BMP server. The BMP Path Marking is defined to be prepended in the BMP Route Monitoring (RM) Message. 2. Path Marking TLV for the RM Message As per RFC4271 [RFC4271], the BMP RM Message consists of the Common Header, Per-Peer Header, and the BGP Update PDU. According to draft- lucente-bmp-tlv [I-D.lucente-bmp-tlv] , optional trailing data in TLV format is allowed in the BMP RM Message to convey characteristics of transported NLRIs (i.e. to help stateless parsing) or vendor-specific data. Such TLV types are to be defined for each application. To include the path status along with each BGP path, we define the Path Marking TLV, shown as follows. 0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 +-------------------------------+-------------------------------+ | Type (2 octets) | Length (2 octets) | +-------------------------------+-------------------------------+ | Path Type(4 octets) | +---------------------------------------------------------------+ | Reason String(Variable) | +---------------------------------------------------------------+ Figure 1: Path Marking TLV o Type = TBD1 (2 Octets): Path Marking. o Length (2 Octets): indicates the length of the value field of the Path Marking TLV. The value field further consists of the Path- Status field and Reason String field. o Path-Status (4 Octets): indicates the path status of the BGP Update PDU encapsulated in the RM Message. Currently 8 types of path status are defined, as shown in Table 1. o Reason String (Variable): indicates the reasons/explanations of the path status indicated in the Path Type field. The detailed Reason String format is defined in Figure 2. Cardona, et al. Expires May 3, 2020 [Page 3] Internet-Draft BMP path marking tlv October 2019 2.1. Path Type +--------+----------------------+ | Value | Path type | +-------------------------------+ | 0x0000 | Unknown | | 0x0001 | Best path | | 0x0002 | Best external path | | 0x0004 | Primary path | | 0x0008 | Backup path | | 0x0010 | Non-installed path | | 0x0020 | Unreachable next-hop | +--------+----------------------+ Table 1: Path Type The Path type field contains a bitfield where each bit encodes a specific role of the path. Multiple bits may be set when a path is used in multiple roles. The best-path is defined in RFC4271 [RFC4271] and the best-external path is defined in draft-ietf-idr-best-external [I-D.ietf-idr-best-external]. A primary path is a recursive or non-recursive path that can be used all the time as long as a walk starting from this path can end to an adjacency draft-ietf-rtgwg-bgp-pic [I-D.ietf-rtgwg-bgp-pic]. A prefix can have more than one primary path if multipath is configured draft-lapukhov-bgp-ecmp-considerations [I-D.lapukhov-bgp-ecmp-considerations]. A best-path is also considered as a primary path. A backup path is also installed in the RIB, but it is not used until some or all primary paths become unreachable. Backup paths are used for fast convergence in the event of failures. All other reachable paths are marked as 'Non-installed'. Lastly, all paths that are considered unreachable are marked as 'Unreachable next-hop'. Unreachable paths may be sent only in some specific cases. 2.2. Reason String Cardona, et al. Expires May 3, 2020 [Page 4] Internet-Draft BMP path marking tlv October 2019 0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 +-------------------------------+-------------------------------+ | Sub Type 1 (2 octets) | Length (2 octets) | +-------------------------------+-------------------------------+ | Non-Best Reason String(Variable) | +-------------------------------+-------------------------------+ | Sub Type 2 (2 octets) | Length (2 octets) | +-------------------------------+-------------------------------+ | Uninstalled Reason String(Variable) | +-------------------------------+-------------------------------+ | Sub Type 3 (2 octets) | Length (2 octets) | +-------------------------------+-------------------------------+ | Unreachable Reason String(Variable) | +---------------------------------------------------------------+ Figure 2: Reason String field The reason string fields include multiple TLVs containing freeform ASCII encoded messsages containing the reason of a specific path status. o Sub Type 1 (2 Octets) = TBD2: Non-Best Reason String. o Length (2 Octets): indicates the length of the value field of the Non-Best Reason String. o Non-Best Reason String (Variable): includes the reason why the path has a non-best status. o Sub Type 2 (2 Octets) = TBD3: Uninstalled Reason String. o Length (2 Octets): indicates the length of the value field of the Uninstalled Reason String. o Uninstalled Reason String (Variable): includes the reason why the path has an uninstalled status. o Sub Type 3 (2 Octets) = TBD4: Unreachable Reason String. o Length (2 Octets): indicates the length of the value field of the Unreachable Reason String. o Unreachable Reason String (Variable): includes the reason why the path has an unreachable status. Cardona, et al. Expires May 3, 2020 [Page 5] Internet-Draft BMP path marking tlv October 2019 3. Acknowledgements TBD. 4. IANA Considerations This document requests that IANA assign the following new parameters to the BMP parameters name space. 4.1. Path Marking TLV This document defines the Path Marking TLV with Type = TBD1: Path Marking (Section 2). 4.2. Path Marking TLV Reason String This document defines three new sub types of the Reason String in the Path Marking TLV (Section 2.2). Sub Type 1 = TBD2: Non-Best Reason String. Sub Type 2 = TBD3: Uninstalled Reason String. Sub Type 3 = TBD4: Unreachable Reason String. 5. Security Considerations It is not believed that this document adds any additional security considerations. 6. Normative References [I-D.ietf-idr-best-external] Marques, P., Fernando, R., Chen, E., Mohapatra, P., and H. Gredler, "Advertisement of the best external route in BGP", draft-ietf-idr-best-external-05 (work in progress), January 2012. [I-D.ietf-rtgwg-bgp-pic] Bashandy, A., Filsfils, C., and P. Mohapatra, "BGP Prefix Independent Convergence", draft-ietf-rtgwg-bgp-pic-10 (work in progress), October 2019. [I-D.lapukhov-bgp-ecmp-considerations] Lapukhov, P. and J. Tantsura, "Equal-Cost Multipath Considerations for BGP", draft-lapukhov-bgp-ecmp- considerations-02 (work in progress), July 2019. Cardona, et al. Expires May 3, 2020 [Page 6] Internet-Draft BMP path marking tlv October 2019 [I-D.lucente-bmp-tlv] Lucente, P., Gu, Y., and H. Smit, "TLV support for BMP Route Monitoring and Peer Down Messages", draft-lucente- bmp-tlv-00 (work in progress), July 2019. [RFC2119] Bradner, S., "Key words for use in RFCs to Indicate Requirement Levels", BCP 14, RFC 2119, DOI 10.17487/RFC2119, March 1997, . [RFC4271] Rekhter, Y., Ed., Li, T., Ed., and S. Hares, Ed., "A Border Gateway Protocol 4 (BGP-4)", RFC 4271, DOI 10.17487/RFC4271, January 2006, . [RFC7854] Scudder, J., Ed., Fernando, R., and S. Stuart, "BGP Monitoring Protocol (BMP)", RFC 7854, DOI 10.17487/RFC7854, June 2016, . [RFC8174] Leiba, B., "Ambiguity of Uppercase vs Lowercase in RFC 2119 Key Words", BCP 14, RFC 8174, DOI 10.17487/RFC8174, May 2017, . Authors' Addresses Camilo Cardona NTT 164-168, Carrer de Numancia Barcelona 08029 Spain Email: camilo@ntt.net Paolo Lucente NTT Siriusdreef 70-72 Hoofddorp, WT 2132 Netherlands Email: paolo@ntt.net Cardona, et al. Expires May 3, 2020 [Page 7] Internet-Draft BMP path marking tlv October 2019 Pierre Francois INSA Lyon France Email: Pierre.Francois@insa-lyon.fr Yunan Gu Huawei Huawei Bld., No.156 Beiqing Rd. Beijing 100095 China Email: guyunan@huawei.com Thomas Graf Swisscom Binzring 17 Zurich 8045 Switzerland Email: thomas.graf@swisscom.com Cardona, et al. Expires May 3, 2020 [Page 8]