BESS Working Group G. Mirsky Internet-Draft ZTE Corp. Intended status: Standards Track October 24, 2017 Expires: April 27, 2018 BFD for Multipoint Networks over Point-to-Multi-Point MPLS LSP draft-mirsky-mpls-p2mp-bfd-02 Abstract This document describes procedures for using Bidirectional Forwarding Detection (BFD) for multipoint networks to detect data plane failures in Multiprotocol Label Switching (MPLS) point-to-multipoint (p2mp) Label Switched Paths (LSPs). It also describes applicability of out- band solutions to bootstrap a BFD session in this environment. Status of This Memo This Internet-Draft is submitted in full conformance with the provisions of BCP 78 and BCP 79. Internet-Drafts are working documents of the Internet Engineering Task Force (IETF). Note that other groups may also distribute working documents as Internet-Drafts. The list of current Internet- Drafts is at https://datatracker.ietf.org/drafts/current/. Internet-Drafts are draft documents valid for a maximum of six months and may be updated, replaced, or obsoleted by other documents at any time. It is inappropriate to use Internet-Drafts as reference material or to cite them other than as "work in progress." This Internet-Draft will expire on April 27, 2018. Copyright Notice Copyright (c) 2017 IETF Trust and the persons identified as the document authors. All rights reserved. This document is subject to BCP 78 and the IETF Trust's Legal Provisions Relating to IETF Documents (https://trustee.ietf.org/license-info) in effect on the date of publication of this document. Please review these documents carefully, as they describe your rights and restrictions with respect to this document. Code Components extracted from this document must include Simplified BSD License text as described in Section 4.e of the Trust Legal Provisions and are provided without warranty as described in the Simplified BSD License. Mirsky Expires April 27, 2018 [Page 1] Internet-Draft Multi-Point BFD over P2MP MPLS LSP October 2017 Table of Contents 1. Introduction . . . . . . . . . . . . . . . . . . . . . . . . 2 2. Conventions used in this document . . . . . . . . . . . . . . 2 2.1. Terminology . . . . . . . . . . . . . . . . . . . . . . . 2 2.2. Requirements Language . . . . . . . . . . . . . . . . . . 3 3. Multipoint BFD Encapsulation . . . . . . . . . . . . . . . . 3 3.1. IP Encapsulation of Multipoint BFD . . . . . . . . . . . 3 3.2. Non-IP Encapsulation of Multipoint BFD . . . . . . . . . 4 4. Bootstrapping Multipoint BFD . . . . . . . . . . . . . . . . 4 4.1. LSP Ping . . . . . . . . . . . . . . . . . . . . . . . . 4 4.2. Control Plane . . . . . . . . . . . . . . . . . . . . . . 4 5. Security Considerations . . . . . . . . . . . . . . . . . . . 4 6. IANA Considerations . . . . . . . . . . . . . . . . . . . . . 4 6.1. Source MEP ID IP Address Type . . . . . . . . . . . . . . 4 7. Acknowledgements . . . . . . . . . . . . . . . . . . . . . . 5 8. Normative References . . . . . . . . . . . . . . . . . . . . 5 Author's Address . . . . . . . . . . . . . . . . . . . . . . . . 6 1. Introduction [I-D.ietf-bfd-multipoint] defines a method of using Bidirectional Detection (BFD) [RFC5880] to monitor and detect unicast failures between the sender (head) and one or more receivers (tails) in multipoint or multicast networks. This document describes procedures for using such mode of BFD protocol to detect data plane failures in Multiprotocol Label Switching (MPLS) point-to-multipoint (p2mp) Label Switched Paths (LSPs). The document also describes applicability of out-band solutions to bootstrap a BFD session in this environment. 2. Conventions used in this document 2.1. Terminology MPLS: Multiprotocol Label Switching LSP: Label Switched Path BFD: Bidirectional Forwarding Detection p2mp: Point-to-Multipoint FEC: Forwarding Equivalence Class G-ACh: Generic Associated Channel ACH: Associated Channel Header Mirsky Expires April 27, 2018 [Page 2] Internet-Draft Multi-Point BFD over P2MP MPLS LSP October 2017 GAL: G-ACh Label 2.2. Requirements Language The key words "MUST", "MUST NOT", "REQUIRED", "SHALL", "SHALL NOT", "SHOULD", "SHOULD NOT", "RECOMMENDED", "NOT RECOMMENDED", "MAY", and "OPTIONAL" in this document are to be interpreted as described in BCP 14 [RFC2119] [RFC8174] when, and only when, they appear in all capitals, as shown here. 3. Multipoint BFD Encapsulation [I-D.ietf-bfd-multipoint] defines how the tail of multipoint BFD session demultiplexes received BFD control packet when Your Discriminator is not set, i.e. equals zero. Because [I-D.ietf-bfd-multipoint] uses BFD in Demand mode the head of BFD multipoint session transmits BFD control packets with Your Discriminator set to zero. As result, a tail cannot demultiplex BFD sessions using Your Discriminator, as defined in [RFC5880]. [I-D.ietf-bfd-multipoint] requires that in order to demultiplex BFD sessions the tail uses source IP address, My Discriminator and the identity of the multipoint tree which the Multipoint BFD Control packet was received from. The identity of the multipoint tree MAY be provided by the p2mp MPLS LSP label in case of inclusive p-tree or upstream assigned label in case of aggregate p-tree. The source IP address MAY be drawn from the IP header, if BFD control packet transmitted by the head using IP/UDP encapsulation as described in Section 3.1. Non-IP encapsulation case described in Section 3.2. 3.1. IP Encapsulation of Multipoint BFD IP/UDP encapsulation for multipoint BFD over p2mp MPLS LSP follows the same rules as defined in Section 7 [RFC5884] for BFD over p2p LSP: UDP destination port MUST be set to 3784; destination IP address MUST be from the 127/8 range for IPv4 and from the 0:0:0:0:0:FFFF:7F00/104 range for IPv6; if multiple alternative paths for the given p2mp LSP Forwarding Equivalence Class(FEC) exist, the MultipointHead SHOULD use Entropy Label [RFC6790] used for LSP Ping [RFC8029] to exercise that particular alternative path; or the MultipointHead MAY use, as destination IP address, the IP address discovered by LSP Ping traceroute [RFC8029] to exercise that particular alternate path. Mirsky Expires April 27, 2018 [Page 3] Internet-Draft Multi-Point BFD over P2MP MPLS LSP October 2017 3.2. Non-IP Encapsulation of Multipoint BFD Non-IP encapsulation for multipoint BFD over p2mp MPLS LSP MUST use Generic Associated Channel (G-ACh) Label (GAL) [RFC5586] at the bottom of the label stack followed by Associated Channel Header (ACH). Channel Type field in ACH MUST be set to BFD CV [RFC6428]. To provide identity of the MultipointHead for the particular multipoint BFD session this document defines new Source MEP ID type TBA1 Section 6.1 IP Address. If the Length value is 4, then the Value field contains IPv4 address. If the Length value is 16, then the Value field contains IPv6 address. Any other value of the Length field MUST be considered as error and the BFD control packet MUST be discarded. 4. Bootstrapping Multipoint BFD 4.1. LSP Ping MaultipointHead MAY use LSP Ping [RFC8029] using in Target FEC TLV, as appropriate, sub-TLVs defined in Section 3.1 [RFC6425]. 4.2. Control Plane BGP-BFD Attribute [I-D.ietf-bess-mvpn-fast-failover] MAY be used to bootstrap multipoint BFD session on a tail. 5. Security Considerations This document does not introduce new security aspects but inherits all security considerations from [RFC5880], [RFC5884], [RFC7726], [I-D.ietf-bfd-multipoint], [RFC8029], and [RFC6425]. 6. IANA Considerations 6.1. Source MEP ID IP Address Type IANA is required to allocate value (TBD) for the Source Source MEP ID IP Address type from the "CC/CV MEP-ID TLV" registry which is under the "Pseudowire Associated Channel Types" registry. +-------+-------------+---------------+ | Value | Description | Reference | +-------+-------------+---------------+ | TBA1 | IP Address | This document | +-------+-------------+---------------+ Table 1: Source MEP ID IP Address TLV Type Mirsky Expires April 27, 2018 [Page 4] Internet-Draft Multi-Point BFD over P2MP MPLS LSP October 2017 7. Acknowledgements 8. Normative References [I-D.ietf-bess-mvpn-fast-failover] Morin, T. and R. Kebler, "Multicast VPN fast upstream failover", draft-ietf-bess-mvpn-fast-failover-02 (work in progress), March 2017. [I-D.ietf-bfd-multipoint] Katz, D., Ward, D., and J. Networks, "BFD for Multipoint Networks", draft-ietf-bfd-multipoint-10 (work in progress), April 2017. [RFC2119] Bradner, S., "Key words for use in RFCs to Indicate Requirement Levels", BCP 14, RFC 2119, DOI 10.17487/RFC2119, March 1997, . [RFC5586] Bocci, M., Ed., Vigoureux, M., Ed., and S. Bryant, Ed., "MPLS Generic Associated Channel", RFC 5586, DOI 10.17487/RFC5586, June 2009, . [RFC5880] Katz, D. and D. Ward, "Bidirectional Forwarding Detection (BFD)", RFC 5880, DOI 10.17487/RFC5880, June 2010, . [RFC5884] Aggarwal, R., Kompella, K., Nadeau, T., and G. Swallow, "Bidirectional Forwarding Detection (BFD) for MPLS Label Switched Paths (LSPs)", RFC 5884, DOI 10.17487/RFC5884, June 2010, . [RFC6425] Saxena, S., Ed., Swallow, G., Ali, Z., Farrel, A., Yasukawa, S., and T. Nadeau, "Detecting Data-Plane Failures in Point-to-Multipoint MPLS - Extensions to LSP Ping", RFC 6425, DOI 10.17487/RFC6425, November 2011, . [RFC6428] Allan, D., Ed., Swallow, G., Ed., and J. Drake, Ed., "Proactive Connectivity Verification, Continuity Check, and Remote Defect Indication for the MPLS Transport Profile", RFC 6428, DOI 10.17487/RFC6428, November 2011, . Mirsky Expires April 27, 2018 [Page 5] Internet-Draft Multi-Point BFD over P2MP MPLS LSP October 2017 [RFC6790] Kompella, K., Drake, J., Amante, S., Henderickx, W., and L. Yong, "The Use of Entropy Labels in MPLS Forwarding", RFC 6790, DOI 10.17487/RFC6790, November 2012, . [RFC7726] Govindan, V., Rajaraman, K., Mirsky, G., Akiya, N., and S. Aldrin, "Clarifying Procedures for Establishing BFD Sessions for MPLS Label Switched Paths (LSPs)", RFC 7726, DOI 10.17487/RFC7726, January 2016, . [RFC8029] Kompella, K., Swallow, G., Pignataro, C., Ed., Kumar, N., Aldrin, S., and M. Chen, "Detecting Multiprotocol Label Switched (MPLS) Data-Plane Failures", RFC 8029, DOI 10.17487/RFC8029, March 2017, . [RFC8174] Leiba, B., "Ambiguity of Uppercase vs Lowercase in RFC 2119 Key Words", BCP 14, RFC 8174, DOI 10.17487/RFC8174, May 2017, . Author's Address Greg Mirsky ZTE Corp. Email: gregimirsky@gmail.com Mirsky Expires April 27, 2018 [Page 6]