TOC 
Network Working GroupL. Andersson
Internet-DraftEricsson
Intended status: InformationalH. van Helvoort
Expires: November 2, 2010Huawei Technologies
 R. Bonica
 Juniper Networks
 D. Romascanu
 Avaya
 S. Mansfield
 Ericsson
 May 1, 2010


"The use of the OAM Acronym in MPLS-TP"
draft-ietf-opsawg-mpls-tp-oam-def-04.txt

Abstract

At first glance the acronym "OAM" seems to be well known and well understood. Looking at the acronym a bit more closely reveals a set of recurring problems that are revisited time and again. The goal of this document is to find an understanding of the OAM acronym that is useful for the MPLS Transport Profile (MPLS-TP) effort.

This document is a product of a joint Internet Engineering Task Force (IETF) / International Telecommunication Union Telecommunication Standardization Sector (ITU-T) effort to include an MPLS Transport Profile within the IETF MPLS and PWE3 architectures to support the capabilities and functionalities of a packet transport network.

This Informational Internet-Draft is aimed at achieving IETF Consensus before publication as an RFC and will be subject to an IETF Last Call.

[RFC Editor, please remove this note before publication as an RFC and insert the correct Streams Boilerplate to indicate that the published RFC has IETF Consensus.]

Status of this Memo

This Internet-Draft is submitted in full conformance with the provisions of BCP 78 and BCP 79.

Internet-Drafts are working documents of the Internet Engineering Task Force (IETF). Note that other groups may also distribute working documents as Internet-Drafts. The list of current Internet-Drafts is at http://datatracker.ietf.org/drafts/current/.

Internet-Drafts are draft documents valid for a maximum of six months and may be updated, replaced, or obsoleted by other documents at any time. It is inappropriate to use Internet-Drafts as reference material or to cite them other than as “work in progress.”

This Internet-Draft will expire on November 2, 2010.

Copyright Notice

Copyright (c) 2010 IETF Trust and the persons identified as the document authors. All rights reserved.

This document is subject to BCP 78 and the IETF Trust's Legal Provisions Relating to IETF Documents (http://trustee.ietf.org/license-info) in effect on the date of publication of this document. Please review these documents carefully, as they describe your rights and restrictions with respect to this document. Code Components extracted from this document must include Simplified BSD License text as described in Section 4.e of the Trust Legal Provisions and are provided without warranty as described in the Simplified BSD License.



Table of Contents

1.  Introduction
2.  OAM and O, A and M
    2.1.  OAM as a functional unit
    2.2.  The acronym broken up
        2.2.1.  O in OAM
        2.2.2.  A in OAM
        2.2.3.  M in OAM
3.  Use of the OAM Acronym in the MPLS-TP effort
4.  Acronyms for the MPLS-TP effort
5.  IANA considerations
6.  Security considerations
7.  Acknowledgments
8.  Informative references
§  Authors' Addresses




 TOC 

1.  Introduction

The purpose of this document is to provide a definition of the OAM acronym such that it is useful for MPLS-TP. The acronym OAM is frequently used in the data and telecommunication industry. One would assume that something that is so widely used is very clearly defined. However a closer look reveals some points that need to be clarified.

The examples below show a number of different ways that the OAM acronym could be expanded and understood. The examples come from many sources including some of the early MPLS-TP I-Ds.

Sometimes there is a fourth letter added to the acronym:

If such an important piece of our technology is so poorly defined, or if there are dialects of the technology with different understandings of such a key concept, this will eventually cause problems.

Trying to understand the use of an acronym that is as "content-rich" as OAM reveals two levels of complexity. First, each letter in the acronym represents an integrated piece of functionality; secondly the acronym as such represents something that is more than just the sum of its parts.

There is also the issue of how each piece of the acronym is defined. This document provides an analysis of how each piece of the acronym is defined and provides possible interpretations of the acronym. Finally the interpretation of the OAM acronym to use for the MPLS-TP effort based on the agreement reached in the JWT (Joint Working Team) report [1] (Bryant, S. and L. Andersson, “Joint Working Team (JWT) Report on MPLS Architectural Considerations for a Transport Profile,” February 2009.) is provided.

Another useful document to make the OAM term understandable in a wider scope is found in An Overview of Operations, Administration, and Maintenance (OAM) Mechanisms (Mizrahi, T., “An Overview of Operations, Administration, and Maintenance (OAM) Mechanisms,” January 2010.) [2].

This document is a product of a joint Internet Engineering Task Force (IETF) / International Telecommunication Union Telecommunication Standardization Sector (ITU-T) effort to include an MPLS Transport Profile within the IETF MPLS and PWE3 architectures to support the capabilities and functionalities of a packet transport network.



 TOC 

2.  OAM and O, A and M



 TOC 

2.1.  OAM as a functional unit

Operations And Maintenance (OAM): A group of network management functions that provide network fault indication, performance information, and data and diagnosis functions. ATM OAM ITU-T I.610 (International Telecommunication Union, “B-ISDN operation and maintenance principles and functions,” February 1999.) [4] is an example specification that uses this expansion of the OAM acronym.

Operations, Administration, and Maintenance (OAM): A group of network management functions that provide network fault indication, fault localization, performance information, and data and diagnosis functions. Examples where this acronym is used are Clause 57 of IEEE 802.3-2008 (IEEE, “Information technology - Telecommunications and information exchange between systems - Local and metropolitan area networks - Specific requirements - Part 3: Carrier sense multiple access with collision detection (CSMA/CD) access method and physical layer specifications",” December 2008.) [3] and ITU-T Y.1731 (International Telecommunication Union, “OAM functions and mechanisms for Ethernet based networks,” February 2008.) [8].

The ITU-T M.3010 (International Telecommunication Union, “Principles for a telecommunications management network,” February 2000.) [7] Recommendation defines operations systems function as a function block that processes information related to the telecommunications management for the purpose of monitoring/coordinating and/or controlling telecommunication functions including management functions (i.e. the TMN (Telecommunications Management Network) itself).

The Metro Ethernet Forum refers to OAM as the tools and utilities to install, monitor and troubleshoot a network, helping carriers run their networks more efficiently.



 TOC 

2.2.  The acronym broken up



 TOC 

2.2.1.  O in OAM

The O in the OAM acronym invariably stands for "Operations".

However there is some ambivalence in the definition and scope of the term "Operation".

Examples of tools related to "operations" are performance monitoring tools used for service level agreement (SLA) measurement, fault management tools used to monitor the health of nodes and links in the network, and network provisioning tools.



 TOC 

2.2.2.  A in OAM

The A in the OAM acronym mostly stands for "Administration", though in a few cases it seems like "Accounting" is also used. For the purpose of this document it is assumed that "Administration" is the correct expansion of "A".

Examples of "administration" tools are network discovery and planning tools.



 TOC 

2.2.3.  M in OAM

In the list above the M in the OAM acronym stands for "Maintenance" or "Management".

Since Maintenance and Management are defined as two different activities it does not seem to be a good idea to use them interchangeably. The concept behind OAM is management, so it makes more sense to use maintenance as the expansion of the "M" in the acronym.

Examples of "maintenance" tools are implementations of connectivity check, loopback, link trace, and other tools that can be used to monitor and diagnose failures in a network or network element.

The Recommendation ITU-T M.20 (International Telecommunication Union, “Maintenance philosophy for telecommunication networks,” October 1992.) [5] defines maintenance as the whole of operations required for setting up and maintaining, within prescribed limits, any element involved in the setting up of a connection (see the ITU-T M.60 (International Telecommunication Union, “Maintenance terminology and definitions,” March 1993.) [6] Recommendation). The purpose is to properly plan and program the maintenance operations required to establish and maintain a network.

A major aim of the concept of maintenance is to minimize both the occurrence and the impact of failures and to ensure that in case of a failure the correct actions are taken. The ITU-T documents also clearly define a maintenance philosophy.



 TOC 

3.  Use of the OAM Acronym in the MPLS-TP effort

In Section 4 (Acronyms for the MPLS-TP effort) the acronyms as they will be used in the MPLS-TP effort are listed. This section gives some background on the definitions provided.

"Mgt" will be used if an abbreviation for "Management" is needed. This draft does not define Management. It is noted, however, that an important part of management functionality relates to tools to report the state of the network.

In MPLS-TP documents, the OAM acronym is to be used for "Operations, Administration and Maintenance", i.e. excluding provisioning.

OAM tools and protocols and the "Management space" are complementary in nature. Management focuses on FCAPS (Fault, Configuration, Accounting, Provisioning, and Security) functionality and on manager (or NOC (Network Operations Center)) to device (or network) interaction.

From an architecture point of view OAM protocols and tools deployed in the data plane tend to be "horizontal" i.e. network element to network element while the management protocols tend to be "vertical".

The components of the OAM acronym (and provisioning) are defined as follows:

Even though "Provisioning" is not included in this document, the following definition is provided for completeness.

In general, Provisioning is used to configure the network for providing new services, whereas OAM is used to keep the network in a state that it can support already existing services.

Sometimes it is necessary to talk about the combination of functions and tools supplied by OAM and Management, it is preferred that this is spelled out as "OAM and Management". In cases where an acronym is needed O&M should be used.



 TOC 

4.  Acronyms for the MPLS-TP effort

OAM - Operations, Administration and Maintenance

O&M - OAM and Management

"Mgt" - Management



 TOC 

5.  IANA considerations

This memo includes no request to IANA.



 TOC 

6.  Security considerations

Security is a significant requirement of MPLS-TP. However, this informational document is intended only to provide guidance on the use of the OAM acronym, and the security concerns are, therefore, out of scope.



 TOC 

7.  Acknowledgments

Malcolm Betts from M. C. Betts Consulting Ltd. significantly contributed to this document.



 TOC 

8. Informative references

[1] Bryant, S. and L. Andersson, “Joint Working Team (JWT) Report on MPLS Architectural Considerations for a Transport Profile,” RFC 5317, February 2009 (TXT, PDF).
[2] Mizrahi, T., “An Overview of Operations, Administration, and Maintenance (OAM) Mechanisms,” draft-ietf-opsawg-oam-overview-00 (work in progress), January 2010 (TXT).
[3] IEEE, “Information technology - Telecommunications and information exchange between systems - Local and metropolitan area networks - Specific requirements - Part 3: Carrier sense multiple access with collision detection (CSMA/CD) access method and physical layer specifications",” IEEE Standard 802.3, December 2008.
[4] International Telecommunication Union, “B-ISDN operation and maintenance principles and functions,” ITU-T Recommendation I.610, February 1999.
[5] International Telecommunication Union, “Maintenance philosophy for telecommunication networks,” ITU-T Recommendation M.20, October 1992.
[6] International Telecommunication Union, “Maintenance terminology and definitions,” ITU-T Recommendation M.60, March 1993.
[7] International Telecommunication Union, “Principles for a telecommunications management network,” ITU-T Recommendation M.3010, February 2000.
[8] International Telecommunication Union, “OAM functions and mechanisms for Ethernet based networks,” ITU-T Recommendation Y.1731, February 2008.


 TOC 

Authors' Addresses

  Loa Andersson
  Ericsson
Email:  loa.andersson@ericsson.com
  
  Huub van Helvoort
  Huawei Technologies
Email:  hhelvoort@huawei.com
  
  Ron Bonica
  Juniper Networks
Email:  rbonica@juniper.net
  
  Dan Romascanu
  Avaya
Email:  dromasca@avaya.com
  
  Scott Mansfield
  Ericsson
Email:  scott.mansfield@ericsson.com